I have a Dodo Case for my iPad2 and it is gorgeous. After a few weeks of using the device with the case I really wanted to be able to use the rear camera without taking the device out of the case. After all, it kind of takes away from the point of a case if you have to take the iPad out to use it.
To solve this problem I grabbed my Swiss Army knife with an awl, a ruler and my soldering iron. I measured several times. 3cm from the upper right corner and .5cm from the top was my starting point. I used awl to make the initial hole. I placed my iPad back in the case and it seemed off. I realized that the case holds the iPad slightly above the back of the case so the hole needs to be bigger than some found on other cases. Once the awl could not make the hole any bigger I heated up soldering iron with a large tip and ran it through the hole.
Make sure to run the soldering iron from the back of the case so you burn the book binding into the hole. This creates a bit of a mess during the process. The cardboard like material inside the case is easily cleaned up with a vacuum.
It took about an hour of fiddling with getting the write dimensions for the whole. In the end the strap of the dodo case nearly covers the whole when the case is closed. It looks fairly finished as is. I am going to see if I can find a brass grommet to complete the look. Happy modifying.